Delta Island

Hello,

I have acquired an official Everdrive MD V2 that appears to be bricked, when i switch the console on i get a black screen, trying to boot into the recovery os by holding down A+B=C on controller No1 doesnt work.

There is a very helpful guide on here that describes removing the flash chip (which i can do), however can i bypass this stage & leave the chip in place but reflash the everdrive via the jtag connector instead?.

Thanks for any help

Hello and welcome to Delta island community Robo500.

owever can i bypass this stage & leave the chip in place but reflash the everdrive via the jtag connector instead?.

Krikzz have probably developped somme registry for make that, but we don't have it.

The only solution a this time for us, it's to remove the flash.

Sorry

Hi Xrider,

Many thanks for your help, ok I will remove the flash.

Thanks